DX2040. The next step
Up to 24Mhz switchable bandwidth
The DX2040 has 32 pre-programmed frequencies and incorporates enhanced multi-channel operation with a switching bandwidth of up to 24MHz (that’s equivalent to 3 European or 4 U.S. TV channels).
Internal or external power options
The receiver can be powered for up to 5 (standard) or 10 (lithium) hours by 2xAA 1.5v batteries, available anywhere in the world. Alternatively it can be externally powered (with a supply range from 6-18v DC) using cables available from Audio.
Infrared remote control
Audio’s unique infrared interface allows the user to set all parameters via the SwitchiR, a keyfob-sized remote control unit.
AudiR for Palm
Scanning with signal strength on location is possible through AudiR for Palm (available free). This feature is normally only found on mains powered studio based rack systems.
The DX2040 can be plugged directly into the RK3 portable rack system to allow 3 (or up to 6 by joining two RK3s) receivers to be fed from one set of antennae.
Upgrading from RMS2020 or RMS2000 ranges
If you are upgrading from an earlier Audio system the DX2040 is fully backwards compatible using existing cables via a standard six pin Lemo connector interface.
|Weight||225g (without batteries)|
|Size||136 (h) x 63 (w) x 20 (d) mm|
|Battery required||2 x 1.5V LR6, AA type|
|External supply range||6 – 18V DC|
|Frequency range||470 – 960MHz (specify at time of order)|
|Sensitivity||-98dBm for 40dB SINAD|
|System audio frequency response||50Hz – 18kHz ±1dB|
|Number of switchable frequencies built in||32|
|Switching bandwidth||Up to 24MHz|
|System frequency response||50Hz – 18kHz ±1dB|
|System S/N ratio||96 to over 104dB|
|System THD measured at 1KHz||< 0.2% typical
< 0.3% at gain position 9 with 6dB input in overload
|LED Indicators||Yellow (x2) - diversity switching
Bright red - no signal
Orange - low TX battery
Red - low DX battery
|Output connector||6 pin Lemo? providing transformer balanced microphone level (-26dBV max.) adjustable, headphone level|
|Antenna connector||2 x SMA|
|Temperature range||-20 to +55?C|
|Compliant to||R&TTE 1999/5/EC, FCC|
|miniTX transmitter||T2040 transmitter||SwitchiR controller||Control-X|