
The TXP professional pocket transmitter
Great sound. Greater flexibility.
Added features give you more control
The TXP transmitter is the professional version of the entry level TX transmitter. It’s the same size and weight as the TX but has several additional features that allow you greater control when using it. Like the TX, it’s easy to program, easy to use and delivers crystal clear, professional quality, sound. In addition though, the TXP has three levels of LF giving you more choice of settings in different wind conditions.
External and battery powered
Like the TX transmitter, the TXP can be powered by a single AA battery giving it 4-6 hours of battery life depending on the type of battery used. However, it also has a five pin screw-locking binder connector which allows powering from any 6-18 volt external DC source. There are also two power level settings – high and low.

Easy setup menus
This unit is set up using a series of menus which are viewed in the OLED display. You are guided through the set up by a series of easy-to-read symbols and all parameters are selected using three buttons on the unit’s front panel. It’s so straightforward you won’t need any further written instructions from us.

OLED menu driven displays
This unit has an organic light emitting diode (OLED) display which is extremely clear yet consumes very little power. The screen shows all the important information you need to monitor the system when in use and also displays the En2’s unique easy set-up menu.
TXP Sepcifications
Frequency range | 470 - 960MHz (specify at time of order) |
Switching bandwidth | Up to 40MHz in 25kHz steps |
Number of frequency tables | Up to 10 |
Number of factory pre-set frequencies | 32 in each table |
Number of user selectable frequencies | 32 in each table (selectable in 25kHz steps) |
Modulation Mode | Wideband FM |
Frequency stability | ±0.002% |
Audio frequency response | 50 – 18kHz |
Signal-to-noise ratio | >100dB (±45kHz deviation) |
Total harmonic distortion | <0.3% typ. |
Output Power | 50mW or 20mW nominal, selectable |
Audio gain control | 0-35dB in 8 steps plus 2 steps for line input |
LF cut | 3 settings; flat, 80Hz, 120Hz |
Input connector | Binder™ 5 pin screw-locking |
Display | OLED blue, 128x32 pixels |
Control | 3 position navigation switch |
Battery type | 1 x 1.5V alkaline LR6 AA size |
Battery life | 4 to 6 hours depending on battery type Audio Ltd recommend use of NiMh |
External supply voltage | 6 – 18V DC (80mA @ 12V) |
Operating temperature range | -20°C to +55°C |
Weight | 118 grams (without batteries) |
Dimensions | 63mm (W) x 82mm (H) x 20mm (D) |
Optional Accessories | Flexible clear antennae straight Input cable 3.5mm to XLR female connector ALM lavalier microphone Neoprene Pouch |